ROM as its default setting, so to finish just save the 'Prefs/Input' with Remove the 'gb' keymap, placing it back into the 'Storage/Keymaps' drawer, Note that those with an American keyboard layout are able to simply Open up the 'Prefs/Locale' requester and select your region, again saving the setting.Select your corresponding keymap and save the setting.Reboot the Amiga and open up the 'Prefs/Input' requester.Place the 'gb' keymap back into the 'Storage/Keymaps' drawer, or it will take up memory.Move the required keymap from the 'Storage/Keymaps' to 'Devs/Keymaps' drawer.In order to change these settings, do the following: Obviously this is no good if you live elsewhere and your time zone and When asked to instert a Workbench 3 disk, hit F12, enter the Floppy Drives tab and select an ADF for DF0:ĬlassicWB defaults to the Great Britain locale and keymap settings.Boot and follow the on-screen instructions.Add the 'System.hdf' file to the Hard Drives tab using 'Add Hardfile' - make sure it's listed as being device DH0: image.Select a relevant ROM file in the ROMS tab.Start WinUAE and load the ClassicWB config.Place the 'ClassicWB.UAE' file into the WinUAE configurations directory.Real Amiga specifications can be found in the Note this is only a suggested set-up - feel free to The informationĪbove is provided in case of config file incompatibility with new releases or vice checked in order to allow CDROM accessĪ WinUAE config file is supplied including these settings. Emulator to run the HDF provided ( WinUAE is assumed)įastest Possible but maintain chipset timingĨMB (Force Settings and Hard Flush boxes cleared).This is required because Workbench is still sold commercially. Vital and copyright files contained on the disk will be copied during the installation.

You'll need a valid Workbench 3.0/3.1 ADF, without one the install will fail. In order to use this Workbench, you MUST follow the install procedure provided.

Workbench 3 adf